All projects
Sparv Embedded Logo
Sparv Embedded2015

Sparv Embedded

A wearable ECG monitor redesigned for Bluetooth and full recordings

Healthcare / Hardware / IoT

Sparv Wearable ECG Monitor

A wearable ECG monitor that needed to do more, with Bluetooth and enough storage to hold a full recording. I was at Sparv Embedded, and the work was consultancy for Linkura, whose name is on the boards. The unit was redesigned around those two requirements, with new firmware to match.

01

A redesign is mostly a component-selection problem

Adding BLE and a large storage capacity to an existing wearable is not a feature you bolt on. It changes the power budget, the layout and the parts list. I did the complete PCB redesign and the component selection behind it, through to the final board design for the ECG unit.

Sparv ECG Unit PCB Design

02

Hand-assembled first, then handed over

A fully hand-assembled prototype run to prove the board, new firmware with BLE integration, and C drivers written for the in-house firmware team to build on. On a short engagement the deliverable that matters is the one the team can carry forward without me.

Engagement
~6 months
Handed over
Board, firmware, drivers
Sparv ECG Unit Assembly

What I owned

System Developer & Hardware Engineer

  • Circuit board redesign of the wearable ECG monitor
  • New firmware with Bluetooth
  • Storage for a full recording, added to the hardware
  • Drivers handed over to the in-house firmware team
  • Hardware design advice and technical support

Hardware Design / PCB Design / Embedded C / BLE / Firmware Development / Driver Development

Gallery

Next step

Tell me what you're building

Send me a short description of the problem and I'll tell you whether I'm the right fit, what it would cost, and how long it would take. No pitch deck.